![]() ![]() The laser comes with a focusing ramp thing and I have that set properly and have moved it both up and down from that point and it appears to get less focused when going away from the suggested height so I believe the laser is properly focused (at least what I am able to do from outside the laser module).LightBurn story by John Walker All you need to know about LightBurn software – main features I have tried changing them both to 255 just to try that and it made no difference. ![]() The value of 1,000 matches Lightburn’s device settings. I have also checked the $30 and $32 values and they are at 1,000 and 1. I have also checked the $110 and 111 values and they are each set to 10,000. I have checked to make sure it is properly on mm/m and not mm/s. I have tried this on both 100 and 80 percent power with speeds of 5,000 mm/m, 3,000 mm/m and 600 mm/m. ![]() The engraver will connect to Lightburn, frame a rectangle or text I put in, and turn the laser on and run the rectangle but the laser won’t engrave or cut. The primary issue is that I cannot get the laser to engrave or cut anything, regardless of the power and speed settings in Lightburn. From what I can tell this is the latest firmware for this device. The firmware I currently have installed on the laser engraver itself is (CR-Laser Falcon User CV-30-Firmware_V3.0.24). I then updated it to the latest firmware and ensured I had the proper drivers installed on my computer and this problem still happens occasionally, but not as often. It still on occasion has difficulty connecting or will restart itself and enter into a sort of loop where it turns on, beeps once, then turns off. I have a brand new Creality CR- Laser Falcon (10W) which had worked initially but had difficulty connecting to my computer. I have read numerous forum posts about similar issues and have already tried numerous solutions provided in those forum posts which I will detail to help save time, perhaps this can become a master list of this issue when it comes to this particular laser engraver as from what I have seen this is a common issue. I would like to thank you in advance for any assistance provided. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |